jmluengor Posted 16 hours ago Posted 16 hours ago I've tested this in many game sessions, and it's very difficult to accelerate this locomotive again after braking. I'm most likely making mistakes, and I would appreciate your help with this. In single-player scenarios, I find it very difficult to regain speed after braking (using the 3 and 9 keys on the numeric keypad progressively), although I eventually manage it and am moving again after a short time, for example, after stopping at a red light. The problem arises in multiplayer scenarios: When I take control of the train, the speed gradually decreases, and it becomes impossible to accelerate until the locomotive comes to a complete stop. I start releasing the brake (key 9 on the numeric keypad), and this takes so long that the bot considers me an inactive player and eventually takes control. I wait a few minutes, take control of the train again, and the same thing happens: The locomotive starts braking, stops, I can't release the pressure from the brake line, and finally the bot takes control of the train again. Frustrating. Any ideas? Thanks for your time.
SIMRAIL Team Królik Uszasty Posted 15 hours ago SIMRAIL Team Posted 15 hours ago It seems you have overcharged the brake pipe with pressure greater than 5 bar. You should not use fill position (↑↑↑) unless you know, what are you doing. The brake lever should not stay there for a long time, rather short impulse and immediately you should go back to assimilation (↑↑) - then the brake pipe overcharges in a controlled manner to only 5,4 bars and goes back to 5,0 bar gradually, when the brake lever is back in "running"/"driving" position. 1
Recommended Posts