the810 Posted November 23, 2023 Share Posted November 23, 2023 Any idea how to restart EN57 after it cuts power due to overspeeding? It happened to me recently on the line and I was able to coast to the next station but despite trying everything I could think of, it just refused to drive, no power was supplied. Link to comment Share on other sites More sharing options...
Fightdrug Posted November 23, 2023 Share Posted November 23, 2023 it is the same way as by the EU07/EP08 ther is a switch in the cabin what disable the releaise for the motors you need to switch that and you can try again 🙂 Link to comment Share on other sites More sharing options...
BigVern Posted November 23, 2023 Share Posted November 23, 2023 Or temporarily enable the bot. 10 seconds should sort it. 1 Link to comment Share on other sites More sharing options...
Deadlost Posted November 23, 2023 Share Posted November 23, 2023 I found success with reverser in neutral position and the "unlock traction overload relay" 1 1 1 Link to comment Share on other sites More sharing options...
the810 Posted November 23, 2023 Author Share Posted November 23, 2023 4 hours ago, BigVern said: Or temporarily enable the bot. 10 seconds should sort it. That doesn't work for this kind of issues, because when you deactivate the bot, it falls back to whatever setting you had before. Thanks everyone! I wish there were some troubleshooting manuals 🙂 Link to comment Share on other sites More sharing options...
Fightdrug Posted November 23, 2023 Share Posted November 23, 2023 vor 12 Minuten schrieb the810: That doesn't work for this kind of issues, because when you deactivate the bot, it falls back to whatever setting you had before. Thanks everyone! I wish there were some troubleshooting manuals 🙂 and you dont learn from it when you just actived the bot 😉 1 Link to comment Share on other sites More sharing options...
BigVern Posted November 24, 2023 Share Posted November 24, 2023 19 hours ago, the810 said: That doesn't work for this kind of issues, because when you deactivate the bot, it falls back to whatever setting you had before. Thanks everyone! I wish there were some troubleshooting manuals 🙂 That I wasn't aware of. Probably explains why a couple of times when I tried that method it didn't work. Link to comment Share on other sites More sharing options...
Atoka220 Posted November 25, 2023 Share Posted November 25, 2023 For me it might have been overloaded under icy wires. I had train heating on and the pantograph fell and i stopped on the main line in the middle of nowhere I tried everything, reverser into neutral, unlocking every overload relay etc, but even for god's sake neither of the pans wanted to go back up again. I activated the bot, allowed it to go on for a while, regained control and i was back to no pantos. Indeed there should be some troubleshooting manual or tutorial cause it was damn embarrassing lol 1 2 Link to comment Share on other sites More sharing options...
Recommended Posts