Quacking Duck Posted 18 hours ago Posted 18 hours ago (edited) There are two brake-related buttons on the control panel of the Dragon 2 locomotive whose functions I do not understand. When the "brake releaser" button is pressed, it rapidly reduces the indicated brake cylinder pressure to 0, but only while it is pressed. When the button is released, brake cylinder pressure returns to approximately its original level. I had originally assumed that this button could accelerate the process of releasing the train's brakes. However, using this button while the brakes are releasing, after having charged the brake pipe to above 5 bar, does not appear to accelerate brake release in any useful way. It appears that there is a "true" level of brake cylinder pressure which can only decrease slowly. When the button is released, indicated brake cylinder pressure returns to that level. Under what circumstances, if any, does this button actually help to release the brakes? Toward the right side of the control panel, near the brake gauges, there is a "brake assimilation" button. Pressing it has no obvious effect. What does this button do, and under what circumstances is it used? Edited 18 hours ago by Quacking Duck 1
jeroezie Posted 14 hours ago Posted 14 hours ago The brake releaser do only work on the locomotives brakes. With old stock, like EU08, EP08 etc. this drains air from a very slow filling reservoir, so the effect will last long. On more modern stock such as Br 186 and dragon locomotives, it drains the locomotives brakes only when being actually pressed. The brake assimilation increased the brake line pressure from 5,0 bar to 5,4 bar. This is to deal with pressure differences in the brake pipe. It will also ensure all triple valves (this valve translates the brake pipe pressure to cylinder pressure that goes to the actual brakes) have an adequate pipe pressure, so they release the brake full, even if they are overcharged (for example by a previous pressure spike). The brake assimilation or fill position, depending on the locomotive, does use a higher pressure and/or a bigger 'hole' in the brake leaver, to fill the brake pipe, so it is a much faster process and filling it only using drive/release position. But you have to be careful to NOT overcharge the triple valves.
Recommended Posts