Jump to content

Recommended Posts

Posted

DGHK will sometimes send a train to DGZ on the left track (track 1). When a train is arriving on track 1 it is impossible to set the entrance signal Y to green. I have to use Sz, and then I cannot confirm train arrival and DGHK AI will not release the lock on track 1, so I cannot send any trains on track 1 for the rest of the session.

When sending trains to DGHK on track 2, I cannot set exit signals U101, U102, U103 or U105 to green, I can only use Sz.

Posted

you cant make signals green via a opposite track before you activate the NP ( opposite track release ) after activate it you can make ways from signal Y, when you give SZ signals you need to press the DKo button first otherwise the magnet dont will register that the train have leave the block between huta and you what means you cant give a signal back to huta that the block is clear

about the other problem make sure you have activate here too the NP first, here is a photo that let you see were that stuff is 🙂 image.thumb.jpeg.1c5a86efd2e31e50bfb5555e2ce11a40.jpeg

  • I agree 2
Posted (edited)

My advice is if it asks for Track 1 is just to ignore it! The AI at DGHK will ask for left track line one if it's closely following a train on Track 2, by which time the train on Track 2 will have cleared the block section and then it'll just send it the second one via track 2 anyway and then you get Track 1 with a stuck line lock in the wrong direction.

(This applies to a lot of location btw, sometimes ignoring the AI for helps the overall train running)

Edited by DazT
Posted
vor 9 Stunden schrieb DazT:

My advice is if it asks for Track 1 is just to ignore it! The AI at DGHK will ask for left track line one if it's closely following a train on Track 2, by which time the train on Track 2 will have cleared the block section and then it'll just send it the second one via track 2 anyway and then you get Track 1 with a stuck line lock in the wrong direction.

(This applies to a lot of location btw, sometimes ignoring the AI for helps the overall train running)

not really useless all the time when you have the fright train from wschodnia it can be really usefull that this one come over track 1 and the other one from poludnioa on track 2 😄

  • I agree 1
Posted (edited)

The problem is though the AI will ask for Track 1 if it's following one immediately behind one on Track 2, it'll ask for it, but not actually send it to you on the track it asked for. IF they fix the AI so it actually sends trains it says it will, then yes, then I agree with you, but until they fix it, it's useless and just locks the line lock for track 1.

This happens at a few other locations as well, it'll ask for Track whatever, but then not send it on that track and just uses the booked one, again, line lock gets stuck.

Normally what I do is if it asks for left line is I check on the big map on the internet and see if there's a valid reason for the AI asking (Usually it's because train B is following right behind train A and just ignoring it, means it'll just send it behind train A, and then not snarl everything up for an hour)

Edited by DazT
Posted

When AI asks for track 1, you can reply with the accepting answer but specifying that you want it on track 2, and it will just wait and send it on the right one.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

Terms of Use Privacy Policy