sammarcomario2010 Posted December 9, 2022 Share Posted December 9, 2022 There is no way to raise the pantograph, the battery is on and the cab is enable and the pantograph light is on, but there is no voltage Whwre am I vrong? Link to comment Share on other sites More sharing options...
TheShotte Posted December 9, 2022 Share Posted December 9, 2022 (edited) Battery on, raise panto, close Main Circuit Breaker. Also, have a look here. Again, I am assuming you are talking about the EU07. Edited December 9, 2022 by TheShotte Link to comment Share on other sites More sharing options...
BigVern Posted December 9, 2022 Share Posted December 9, 2022 I am currently having the same issue here. Tried both the EMU and EU07. Places me in the cab under autopilot with train stationary. Take the train out of AI control, everything is shown "on" but the pantographs are not raised. Toggling the switches has no effect, they stay down. I tried shutting down the cab and battery then switching on, following the procedure in the EU07 guide. Still can't get the pantograph(s) to raise. The only factor might be prior to the run starting I had the server disconnected message each time, but it then loaded with a message that the session was interrupted. However I can escape from that screen into the cab where, as noted above, nothing is working. Very frustrating! 1 Link to comment Share on other sites More sharing options...
Recommended Posts