CaptainSMan

Yeah, did that last night actually. I botched something up when I cancelled a route after changing my mind trying to shuffle a Passenger and Freight train, and the Po (red arrow in this case) didn't clear on the opposite side of the line this time. I couldn't set the route or reset anything again, and a real person was driving the train this time, there's certainly a lot more pressure with a real person driving 🙂 Anyway I notified him that there was a problem with the switching and that I would get him moving with the Sz. They understood and once the signal came through he was on his way. Once he cleared the block everything went back to normal. Very cool.

I just tried this. I let the first train go through without setting Po. For the next train; Contacted the despatcher down the line (AI) if the line was clear for the next train (xxxxx) Received the all clear set Sz (the route is not highlighted as normal but the train gets moving) set Po The train slowly went through and once it arrived on the other side the AI despatcher set the Ko, the indication above Po1T was cleared back to white and all was normal again...brilliant! Thanks! Man this sim keeps blowing me away.

I see, thanks.

Thanks guys, makes sense. Is there a recovery procedure if you do forget/miss pressing the PO in time or is logging off the only option? What would happen in RL (a lot of radio comms and KURWA'ing I suspect)?

I'm trying to understand how to operate the departures on Line 1 to Dabrowa Gornicza Strzemieszyce (DGS) or if there's a possible issue with it. At the start of my session the line looks like this, and it's happy to let me set the route from Line1 to DGS... The train makes its departure... If I do nothing and the train has departed, I am unable to set the route for future departures. If I press it after the train has passed the Po1T indication is Red and the Pwl1T is Off and also unable to set the route. Pressing the departure override - dPo1T doesn't seem to do anything. But, when I press Po1T as the train is departing as shown below... The occupancy status above Po1T stays Red and Pwl1T goes Off... Some time after the train has departed the occupancy status above Po1T is set back to White (I'm assuming the station down the line has acknowledged the Arrival and line is cleared) and I can use the route again for the next departure ok. So this is the manual process for handling the track occupancy I'm guessing, but is it supposed to be this unforgiving when you miss setting Po, or is there some way to get out of the stuck situation when you forget to do it? Cheers, SMan PS: I think I just encountered a similar thing on the line to Koziol. Missed setting Po2k and now can't send any more trains down the line 😐