jiklobka Posted January 3, 2023 Share Posted January 3, 2023 At Bedzin Ksawera, direction Katowice, the zone for correct stopping at platform could be adjusted a little. I've stopped with the whole train at the platform as close as possible to the access for passangers and had to pull some 5 meters after I turned the HUD on and found out that the stop hasn't been chceked off. Thank you for your work! Link to comment Share on other sites More sharing options...
SIMRAIL Team Stele Posted January 3, 2023 SIMRAIL Team Share Posted January 3, 2023 Platform has 200m and W4 sign in direction of Katowice reads 202m+3m to end of platform from it's placement. So it's looks right from signal configuration perspective at least. In direction of Dąbrowa there was no offset defined, but that shouldn't matter in your case. Link to comment Share on other sites More sharing options...
SIMRAIL Team Admin BOT Posted January 3, 2023 SIMRAIL Team Share Posted January 3, 2023 Thank you for reporting this issue! Dziękujemy za zgłoszenie tego problemu! Internal Ticket \ Wewnętrzny ticket: https://git.simkol.pl/simkol/unitysim-new/-/issues/1210 Link to comment Share on other sites More sharing options...
SIMRAIL Team Stele Posted January 3, 2023 SIMRAIL Team Share Posted January 3, 2023 Calculations for point where you can stop seems to be fine. 22we was 0.75m longer in config file than the model, but did you stopped that close, that this would matter? Link to comment Share on other sites More sharing options...
SIMRAIL Team Stele Posted January 3, 2023 SIMRAIL Team Share Posted January 3, 2023 Platform also might be a bit longer. Like 202.5m. So couple centimeters here and there and stop didn't triggered. Link to comment Share on other sites More sharing options...
Recommended Posts