Skully Posted December 17, 2022 Posted December 17, 2022 After watching some streams I think most people don't realize how to setup a complete train route. Folks would just start at one signal, take the next and form the route. So to setup a complete train route (across multiple signals or alternate paths) you first click the start signal then the signal all the way at the end of the route followed by any intermediate signal or point over which you want the train to pass. Then you execute on the train route. 🚂
Skully Posted December 17, 2022 Author Posted December 17, 2022 4 minutes ago, Xanax said: That manual could definitely use some augmentation for this.
Solution SurvivorSean Posted December 17, 2022 Solution Posted December 17, 2022 Note I didn't write the manual just replied 🙂 However setting a route completely form one end to the other DOES NOT work with ALL signal boxes. Some you will have to set up a segment at a time. I'm still not sure why that is but it will tell you now as the UI has been improved for English with the errors. I'll have to try it again and see if I get an error after executing. Thanks Sean
Recommended Posts